Kia Optima: RCCW (Rear Cross-Traffic Collision Warning) / Warning message

Kia Optima DL3 2019-2024 Owner's Manual / Driving your vehicle / Blind-spot Collision Warning (BCW) / RCCW (Rear Cross-Traffic Collision Warning) / Warning message

The sensor may be limited when the below conditions.

If there is a problem with the BCW system, a warning message will appear and the light on the switch will turn off. The system will turn off automatically.

Turn off the system by pressing the BCW switch and deselecting Rear Cross-Traffic Collision Warning (RCCW) from the User Settings mode on the cluster, when using a trailer or carrier behind your vehicle.

If any of these conditions occur, the light on the BCW switch and the system will turn off automatically.

When the BCW canceled warning message is displayed in the cluster, check to make sure that the rear bumper is free from any dirt or snow in the areas where the sensor is located. Remove any dirt, snow, or foreign material that could interfere with the radar sensors.

After any dirt or debris is removed, the BCW system should operate normally after about 10 minutes of driving the vehicle.

If the system still does not operate normally have your vehicle inspected by an authorized Kia dealer.

If the system does not work properly, a warning message will appear and the light on the switch will turn off.The system will turn off automatically.

In this case, take your vehicle to an authorized Kia dealer and have the system checked.

Non-operating condition

Outside rearview mirror may not alert the driver when:

- The outside rearview mirror housing is damaged or covered with debris.
- The mirror is covered with dirt, snow, or debris.
- The window is covered with debris.
- The windows are severely tinted.

Warning type
If the vehicle detected by the sensors approaches your vehicle, the warning chime will sound, the warning light on the outside rearview mirror will blink and a message will appear on the LCD ...

Driver's Attention
The driver must be cautious in the below situations, because the system may not detect other vehicles or objects in certain circumstances. - When a trailer or carrier is installed. - The vehicle d ...

Other information:

Kia Optima DL3 2019-2024 Service and Repair Manual: Compressor


Description and operation Description The compressor is the power unit of the A/C system. It is located on the side of engine block and driven by a V-belt of the engine. The compressor changes low pressure and low temperature refrigerant gas into high pressure and high temperatu ...

Kia Optima DL3 2019-2024 Service and Repair Manual: Cowl Cross Bar Assembly


Components and components location Component Location 1. Cowl cross bar assembly Repair procedures Replacement    • When removing with a flat- ...

Copyright © www.kioptima.com 2017-2024