Kia Optima: Crash Pad / Steering Column Shroud Panel
Components and components location

1. Steering column shroud lower
panel
|
2. Steering column shroud upper
panel
|
Repair procedures
[Steering column shroud
upper panel]
• |
When removing with a flat-tip screwdriver or remover, wrap protective
tape around the tools to prevent damage to components.
|
• |
Use a plastic panel removal tool to remove interior trim pieces
without marring the surface.
|
• |
Take care not to bend or scratch the trim and panels.
|
• |
Put on gloves to prevent hand injuries.
|
|
1. |
Lower the steering wheel.
|
2. |
Using a screwdriver or remover, remove the crash pad side cover [LH]
(A).

|
3. |
Using a screwdriver or remover, remove the steering column shroud upper
panel (A).

|
4. |
After loosening the mounting screw, remove the crash pad garnish [LH]
(A).

|
5. |
To install, reverse removal procedure.
Replace any damaged clips (or pin-type retainers).
|
|
[Steering column shroud
lower panel]
1. |
Remove the crash pad lower panel.
(Refer to Crash Pad - "Crash Pad Lower Panel")
|
2. |
Loosen the mounting screws by turning the steering wheel to the left
and right, and remove the steering column shroud lower panel (A).

|
3. |
To install, reverse removal procedure.
Replace any damaged clips (or pin-type retainers).
|
|
Components and components location
Component Location
1. Crash pad lower panel
Repair procedures
Replacement
...
Components and components location
Component Location
1. Crash pad garnish [LH]
2. Crash pad garnish [RH]
3. Crash pad center garnish
Repair pro ...
Other information:
Repair procedures
Removal
1.
Disconnect the negative (-) battery cable.
2.
Remove the stabilizer bar bushing (A).
Tightening torque :
7.8 - 9.8 N.m (4.5 - 5.5 kgf.m, 5.8 - 7.2 lb-ft)
...
Components and components location
Components
1. Front muffler
2. Catalytic converter & Center muffler assembly
3. Rear muffler
4. Gasket
5. Hanger
Repair procedures
Removal and Installation
Front Muffler
1.
...