Kia Optima: Driving your vehicle / Cruise Control System
The cruise control system allows you to program the vehicle to maintain a constant
speed without depressing the accelerator pedal.
This system is designed to function above approximately 30 km/h (20 mph).
If the cruise control is left on, (CRUISE indicator light in the instrument cluster
illuminated) the cruise control can be switched on accidentally. Keep the cruise
control system off (CRUISE indicator light OFF) when the cruise control is not in
use, to avoid inadvertently setting a speed.
Use the cruise control system only when traveling on open highways in good weather.
Do not use the cruise control when driving in heavy or varying traffic, or on
slippery (rainy, icy or snow-covered) or winding roads or over 6% up-hill or down-hill
roads.
✽ NOTICE
- During normal cruise control operation, when the SET switch is activated
or reactivated after applying the brakes, the cruise control will activate after
approximately 3 seconds. This delay is normal.
- To activate cruise control, depress the brake pedal at least once after
turning the ignition switch to the ON position or starting the engine. This
is to check if the brake switch which is important part to cancel cruise control
is in normal condition.
WARNING - Misuse of Cruise Control
Do not use cruise control if the traffic situation does not allow you to drive
safely at a constant speed and with sufficient distance to the vehicle in front.
The sensor may be limited when:
The pedestrian is not fully detected by the camera recognition system, for
example, if the pedestrian is leaning over or is not fully walking upright
The pedes ...
1. Press the CRUISE button on the steering wheel to turn the system on. The CRUISE
indicator light in the instrument cluster will illuminate.
2. Accelerate to the desired speed, which must be mor ...
Other information:
Components and components location
Components
1. Strut assembly
2. Insulator dust cap
3. Insulator
4. Spring upper pad
5. Strut bearing
6. Strut bearing pad
7. Bumper rubber
8. Coil spring
9. Spring lower pad
Repair procedur ...
The outside (fresh) air position is automatically selected, when the sunroof
is opened.
When you select the recirculated air position, the system maintains the recirculated
air position for 3 minutes and then automatically converts to the outside (fresh)
air position.
When the sunroof is clo ...