Kia Optima: If you have a flat tire (with Tire Mobility Kit) / Checking the tire inflation pressure

Kia Optima DL3 2019-2024 Owner's Manual / What to do in an emergency / If you have a flat tire (with Tire Mobility Kit) / Checking the tire inflation pressure

1.After driving approximately 7 ~ 10 km (4 ~ 6 miles) or about 10 minutes, stop at a suitable location.

2.Connect the filling hose (3) of the compressor (clip mounted side) directly and then connect the filling hose (3) (opposite side) to the tire valve.

3.Connect between compressor and the vehicle power outlet using the cable and connectors.

4.Adjust the tire inflation pressure to 200 kPa (29 psi). With the ignition switched on, proceed as follows.

- To increase the inflation pressure: Switch on the compressor, position I. To check the current inflation pressure setting, briefly switch off the compressor.

WARNING

Do not let the compressor run for more than 10 minutes, otherwise the device will overheat and may be damaged.

- To reduce the inflation pressure: Press the button (9) on the compressor.

CAUTION - Tire pressure sensor

When you use the Tire Mobility Kit including sealant not approved by Kia, the tire pressure sensors may be damaged by sealant. The sealant on the tire pressure sensor and wheel should be removed when you replace the tire with a new one and inspect the tire pressure sensors at an authorized dealer.

Using the Tire Mobility Kit
1. Detach the speed restriction label (1) from the sealant bottle (2), and place it in a highly visible place inside the vehicle such as on the steering wheel to remind the driver not to drive too ...

Technical Data
System voltage: DC 12 V Working voltage: DC 10 - 15 V Amperage rating: max. 15 A ± 1A (at DC 12V operation) Suitable for use at temperatures: -30 ~ +70°C (-22 ~ +158°F) Max. working pressure: 6 ...

Other information:

Kia Optima DL3 2019-2024 Service and Repair Manual: Cruise Control (CC) Switch


Components and components location Components 1. Left remote control switch (Audio + Bluetooth + Voice) 2. Right remote control switch (Trip + SCC + LFA) Schematic diagrams Circuit Diagram Repair procedures Removal ...

Kia Optima DL3 2019-2024 Owner's Manual: Securing a child restraint with the LATCH anchors system


To install a LATCH-compatible child restraint in either of the rear outboard seating positions: 1. Move the seat belt buckle away from the lower anchors. 2. Move any other objects away from the anchors that could prevent a secure connection between the child restraint and the lower anchors. 3. ...

Copyright © www.kioptima.com 2017-2024